CrimeStopper RS-1 Manuel d'utilisateur télécharger pdf (Page 8)

LED: 2 PIN PLUG

The LED is used for Remote Start Diagnostics and a Valet indicator. It will also Flash for use as security deterrent.

VALET / PROGRAM SWITCH

STATUS LED

WIRING Low Current 3 Pin Plug

Blue/orange

Orange/white

Green

(-) START

(-) ACC, IGN, Aux 2

(-) Start Activation

RED 3 PIN PLUG

ORANGE / WHITE (-) ACC, IGN or AUX 2 OUTPUT (Programmable option 24)

This output is selectable (-) Accessory, (-) Ignition or (-) AUX 2. Default = (-) ACC

BLUE / ORANGE (-) STARTER OUTPUT: Some vehicle require a (-) Start for “Push to Start”.

GREEN (-) START ACTIVATION INPUT or OEM INTERFACE (3 Pulse Start)

Option 17-1 OEM Interface (3 Pulse Start):

This mode allows the system to Remote Start or Stop with 3 successive Lock pulses. There are 2 Modes of operation.

1. Remote Start thru data (green wire not connected). This feature only works on newer CANBUS vehicle using a

Data Module that supports this feature. With this option you can use both the OEM and Crimestopper remote.

2. Connect the Green input wire to the Negative lock signal wire of the factory system. If your Factory OEM system

does not have this type of signal, then a relay is required.

Option 17-2 Default (-) Neg. Start Activation (1 Pulse Start):

This wire allows an alarm or keyless entry system with a remote Aux channel to activate the Remote Start by sending a

(-) momentary pulse to the Green input wire. This triggers a remote engine start or stop

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 29 30

Pas de commentaire

CrimeStopper RS-1 Manuel d'utilisateur Page 8