CrimeStopper SP-100 Instructions d'exploitation télécharger pdf (Page 15)

LED / VALET SWITCH MOUNTING

LED: The LED is used as a System Status Indicator and it will also FLASH for use as security deterrent when

the Alarm System is Armed.

VALET SWITCH: Mount the Valet Switch (push-button) on dash or other accessible location. It is REQUIRED

for Emergency Disarm, Programming and entering Valet Mode (See pg 13 for Valet Mode).

VALET / PROGRAM SWITCH

STATUS LED

WIRING: SHOCK SENSOR

4 PIN SENSOR PLUG/HARNESS (RED):

GREEN Wire: Negative Trigger.

WHITE Wire: Negative Warn-A-Way.

BLACK Wire: Sensor Ground.

RED Wire: Sensor 12V Power.

SHOCK SENSOR: The sensor supplied with

this system does not require any additional

wiring. Simply mount the sensor in a suitable

location, plug it in, and adjust the sensitivity.

SENSOR ADJUSTMENT

Clockwise = Higher Sensitivity

Counter Clockwise = Lower Sensitivity

1 2 ... 10 11 12 13 14 15 16

Pas de commentaire

CrimeStopper SP-100 Instructions d'exploitation Page 15